Walls, Floors and Furniture
To remove soot and smoke from walls, furniture and floors, use a mild soap or detergent or mix together the following solution:
· 4 to 6 tbsp. Tn-Sodium Phosphate
· 1 cup household cleaner or chlorine bleach
· 1 gallon warm water
Wear rubber gloves when cleaning with this solution. Be sure to rinse your walls and furniture with clear warm water and dry thoroughly after washing them with this solution.
Wash a small area at one time, working from the floor up. Then rinse the wall with clear water immediately. Ceilings should be washed last.
Do not repaint until walls and ceilings are completely dry
Your wallpaper can also be repaired. Use a commercial paste to repair a loose edge or section. Contact your wallpaper dealer or installer for information on wallpaper cleaners. Washable wallpaper can be cleansed like any ordinary wall, but care must be taken not to soak the paper. Work from bottom to top to prevent streaking.
Wood Furniture
|
• |
Do not dry your furniture in the sun. The wood will warp and twist out of shape. |
|
• |
Clear off mud and dirt. |
|
• |
Remove drawers. Let them dry thoroughly so there will be no sticking when you replace them. |
|
• |
Scrub wood furniture or fixtures with a stiff brush and a cleaning solution. |
|
• |
Wet wood can decay and mold, so dry thoroughly. Open doors and windows for good ventilation. Turn on your furnace or air conditioner, if necessary. |
|
• |
If mold forms, wipe the wood with a cloth soaked in a mixture of borax dissolved in hot water. |
To remove white spots or film, rub the wood surface with a cloth soaked in a solution of 1/2 cup household ammonia and 1/2 cup water. Then wipe the surface dry and polish with wax or rub the surface with a cloth soaked in a solution of 1/2 cup turpentine and 1/2 cup linseed oil. Be careful - turpentine is combustible.
You can also rub the wood surface with a fine grade steel wool pad dripped in liquid polishing wax, clean the area with a soft cloth and then buff.
Money Replacement
Handle burned money as little as possible. Attempt to encase each bill or portion of a bill in plastic wrap for preservation. If money is only half-burned or less (if half or more is still intact), you can take the remainder to your regional Federal Reserve Bank for replacement. Ask your bank for the nearest one. Or you can mail the burned or torn money by "registered mail, return receipt requested" to:
Department of the Treasury
Bureau of Engraving and Printing
Office of Currency Standards
P.O. Box 37048
Washington, DC 20013
Mutilated or melted coins can be taken to your regional Federal Reserve Bank or mailed by "registered mail, return receipt requested" to:
Superintendent
U.S. Mint
P.O. Box 400
Philadelphia, PA 19105
If your U.S. Savings Bonds have been destroyed or mutilated, you must obtain Department of Treasury Form PD F 1048 (I) from your bank or www.ustreas.gov and mail to:
Department of the Treasury
Bureau of Public Debt
Saving Bonds Operations
P.O. Box 1328 Parkersburg, WV 26106-1328